Specifications

• Nylon /Kevlar Line
• Stainless Steel Spring and Hardware
• 80 lbs. Breaking Strength
• Locking Mechanism

Mounting System (includes both)

Snap Clip:

• Attaches to D-ring or belt loop

RT3-5252
Clip:

• Clips over belt, pants or strap. Rotates 360 degrees

Velcro Strap:

• Velcro strap securely wraps and cinches around any loop, bar, belt, or strap

RT3-5232
Velcro Strap:

• Velcro strap securely wraps and cinches around any loop, bar, belt, or strap

Retracting End Type

1" Airlock Side Release

• Quickly and easily disconnect transmitter from Gear Keeper.
• Included Accessories:
  1" S/R Velcro Strap (AC0-0400)
• See Other Available Accessories

Quick Connect-II (Q/C-II)

• Quickly and easily disconnect net from Gear Keeper.
• Included Accessories:
  Q/C-II Split Ring (AC0-0916)
• See Other Available Accessories

Usage Notes

There are Two Ways to Connect the Transmitter

Attach to Transmitter with Holster or Lanyard Connection (using Split Ring directly)

• (1) Remove the two screws from
• the Interconnect Clip ( A Phillips screwdriver is required).
• (2) Unfold the Interconnect Clip and remove the S/R Female.
• (3) Install the Split Ring.
• (4) Close Interconnect Clip (Be sure knot in line is recessed into the cavity & line is exiting through the line slot).
• (5) Reinstall screws (do not over-tighten).).

Attach to Transmitter without Holster (using Side Release Velcro Strap)

• (1) Remove button guard.
• (2) Wrap Velcro strap around transmitter.
• (3) Feed strap through plastic loop and cinch tight. Replace button guard.

Attach to Retractor to G2/3 Transmitter

• (1) Attach Split Ring Clamp (A) to body of Transmitter with Screw (B)
• (2) Then, attach Gear Keeper Split Ring to Split Ring Clamp (A)